3DBedFix 600x420mm

Your cart has been successfully updated.
An error occured while trying to update your cart.
  • 3DBedFix 600x420mm
  • 3DBedFix 600x420mm
3DBedFix 600x420mm, for Strateo3D DUAL600 heatbed.
This product benefits from a preferential rate and cannot be subject to any additional one-off or permanent reduction in its price.
90,00 € VAT inc.
75,00 € VAT exc.
To prevent automated spam submissions leave this field empty.

Easy to install, this 3DBedFix is an optimal printing surface, heat resistant and robust, that enhance the adhesion of your printed part on your Strateo3D DUAL600's bed.

Installation:
- Remove the former 3DBedFix, if it's not your first use
- Be sure to have a clean and free of debris bare bed
- Remove the protection film from your new 3DBedFix and apply it to the bare bed, starting from one edge to the opposite one. Be sure not to make bubbles, thanks to a credit card, for example.
- Recalibrate you Z height (a too high calibration will make the extruded filament not adhere to the bed, a too close calibration will flatten too much your first layer and may result in builds
adhering too well to the bed, making it very dif­cult to remove, and/or can damage the sheet).

You're ready to print.

CAUTION : Do not use aceton on the 3DBedFix
Before first use: clean the entire surface with a clean cloth soaked in isopropylic alcohol.
Use a spatula to remove your prints from the surface, to avoid damage the 3DBedFix.


Specifications :

  • Dimension: 600x400mm
Share