3DBedFix patch for MicroDelta Rework

Your cart has been successfully updated.
An error occured while trying to update your cart.
  • 3DBedFix patch for MicroDelta Rework
3DBedFix patch, diameter 150mm, for heatbed.
Out of stock

Easy to install, this 3DBedFix is an optimal printing surface, heat resistant and robust, that enhance the adhesion of your printed part on your 3D printer's bed.
Compatible with MicroDelta Rework.

Installation:
- Remove the former 3DBedFix, if it's not your first use
- Be sure to have a clean and free of debris bare bed
- Remove the protection film from your new 3DBedFix and apply it to the bare bed, starting from one edge to the opposite one. Be sure not to make bubbles, thanks to a credit card, for example.
- Recalibrate you Z height (a too high calibration will make the extruded filament not adhere to the bed, a too close calibration will flatten too much your first layer and may result in builds adhering too well to the bed, making it very dif­cult to remove, and/or can damage the sheet).

You're ready to print.

CAUTION : Do not use aceton on the 3DBedFix
Before first use: clean the entire surface with a clean cloth soaked in isopropylic alcohol.
Use a spatula to remove your prints from the surface, to avoid damage the 3DBedFix.

Specifications :

  • Diameter: 150mm
Share